CASE IH 1020 HEADER SERIAL NUMBERS SERIES

I did some more looking and the only place I can find the newer style setup like you have is on the later SN parts card. Posted 17:03 (#6259820 - in reply to #6259671) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin I don't have it in front of me but believe the serial no is 0220225. Posted 14:36 (#6259671 - in reply to #6259638) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin I think what you are looking for is a 434709A1 which is referred to as an armature or a wiring harness depending on where you look. There are 4 different parts listing for a 1020 depending on SN. Posted 14:11 (#6259638 - in reply to #6259247) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin Look under your grainhead auger, I've seen stuff slid under there. Posted 13:08 (#6259556 - in reply to #6259247) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin Just assumed it went to that sensor as it is a three pin. I know I've always had the round three pin and now it's gone. Never really paid attention to what went where. Have had the same head and combine for years. Posted 13:02 (#6259544 - in reply to #6259488) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin

CASE IH 1020 HEADER SERIAL NUMBERS SERIES

The link below is a little information about the correct pot meter requirements for the earlier series combines to work with a later model head. Posted 12:51 (#6259526 - in reply to #6259247) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pinġ4 to 1020 heads, All I have ever used is 120 volt extension cord plug ends, use the ground prong as one of the 3 wires. Is this a new to you head? The harness to that 3 pin on the throat is a 1 piece harness (until the mice get to it ). Posted 12:33 (#6259488 - in reply to #6259247) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin Posted 11:34 (#6259399 - in reply to #6259378) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin I think that is a resistor for the 14 and 16 series combines. Unsure on the part number for the harness you need but I believe you'll want to remove the short harness you have in your hand if you are running it on a 21 or 23 series machine.

Posted 11:19 (#6259378 - in reply to #6259247) Subject: RE: Case IH 1020 jump harness - sensor to combine 3 pin

Case ih 1020 header serial numbers